Instruction Manual

Closing the computer
1 Slip the base of the logic board into the guide rails inside the computer case and swing
the handle back into its storage position.
2 Press the reset button on the logic board, and then slide the logic board back into the
computer.
1 Press the reset button located on the main logic board
(the bottom-most layer) with a ball-point pen or similar object.
2 Gently but firmly
push the vertical plate
back into the computer
until the logic board is
solidly in place.
Make sure the logic board slides
into the guides that are on both
sides of the computer’s interior.
Swing the handle up,
into its storage position.
154
Appendix B