User`s guide

32 Chapter 1 Installation and Setup Overview
This is the technique you use to set up a local server, as “Setting Up a Local Server
Interactively” on page 94 describes. You can also use this interactive approach to set up
a remote server from an administrator computer. See “Setting Up a Remote Server
Interactively” on page 95 for instructions.
When multiple remote servers can use the same setup data, you can supply the data,
then initiate setup of all the servers at once, using a batch approach. This technique,
shown on the left side of the following picture, requires that network identifiers for all
the target servers be set using DHCP or BootP. See “Setting Up Multiple Remote Servers
Interactively in a Batch” on page 97 for instructions.
Subnet 1
Subnet 2
WelcomeWelcome
Welcome