Hardware manual

Appendix B Setup Example 67
The getting started guide has instructions for other installation methods, such as
installing on a server without an optical drive and installing from a remote computer.
The Preface tells you where to find the getting started guide.
2 When the Installer opens, proceed through its panes by following the onscreen
instructions. If you need to format the target disk, see the getting started guide for
instructions on preparing disks for installing Mac OS X Server.
When installation is complete, the server restarts and Server Assistant opens.
3 Fill out the worksheet on page 53. You’ll need the information as you move through the
Assistant’s panes.
4 Use the Language and Keyboard panes to reflect the server’s administration language.
5 In the Administrator Account pane, enter the server administrator’s names and
password. Click Continue.
6 In the Network Names pane, enter the computer name and local hostname for your
server. Click Continue.
7 Make sure the Network Interfaces pane lists your external and internal Ethernet
interfaces.
Also make sure that the external interface is the first one listed in the Network
Interfaces pane. The first interface listed is the primary, or default, interface. Network
traffic initiated by the server is routed through the primary interface. VPN uses it as the
Public network, treating all others listed as Private.
Click Continue.
8 The TCP/IP Connection pane appears for each Ethernet interface.
For the external interface, choose Manually from the Configure IPv4 pop-up list, then
enter the IP address, subnet mask, and DNS server IP address, or addresses, provided to
you by the ISP. In addition, make sure you add the local DNS server IP address
(192.168.0.1) to those supplied by the ISP. For best performance, make the local DNS
server IP address appear first in the list. Click Continue.
If you’ll be using Gateway Setup Assistant to configure network settings, you don’t
need to set up an internal interface. Otherwise, enter these values for the internal
interface then click Continue:
Configure IPv4: Manually
IP Address: 192.168.0.1 (192.168 values are reserved for internal LANs)
Subnet Mask: 255.255.0.0
Router: 192.168.0.1
DNS Servers: 192.168.0.1