System information

Mac mini (Mid 2011) Take Apart — Antenna Plate 115
2011-07-21
2 Rotate the Antenna
Plate clockwise about
270-degrees to the
position shown. Push
the resulting cable
loop to guide it over
the edge and into the
housing.
3 Slide the antenna
plate into place on
the housing.
Note: The edge of the
plate has a slot that
the edge of the
housing must t into
for the plate to sit at
and the screw holes
to align. (see rough
cross-section example
at right)
4 A tool, such as the
hex wrench, inserted
slightly into one of
the plate holes may
help to lift and
maneuver.
Be careful not to
damage the cosmetic
Mylar on the hard
drive, or allow the
tool to damage the
housing.