Instruction manual

1
51
Io HD Installation and Operation Manual — Using The AJA Control Panel
After doing so, there will be a short time to complete the internal process—and
then you may power down and disconnect the Io HD. From this point, the Io
HD is a stand alone converter and will retain the parameters selected when it is
powered back on. The Io HD remains in Stand Alone Mode until it is once again
connected to a Mac via FireWire. Turning it ON and OFF will not take it out of
Stand Alone Mode until is again connected to a Mac via FireWire.
After Clicking Burn to Save Settings for Stand Alone Mode
After Burn is Complete, Power-down and Disconnect FireWire cable for Standalone
Converter Usage
Note: The AJA Io HD can also be used as a converter device while it is connected to
a Mac if the Default Video Output in the Control tab of the Control Panel application
is set to Input Passthrough.