Instruction manual

1
39
Io HD Installation and Operation Manual — Using The AJA Control Panel
Tabbed Windows—the bottom area of the AJA Control Panel provides different
information categorized by topic. Clicking on a “Tab”-or a block diagram
element-will result in an information screen corresponding to a tabbed topic.
With the mouse on a block diagram element, you can also control click to reveal
drop down menus for certain functions. The arrows at either side of the displayed
tabs can be clicked to see any additional tabs not visible on the screen. If an arrow
is “grayed out”, then it means there are no additional tabs in that direction. Each
of these tabbed windows are described on the following pages.
Tabs available are:
Inputs: view and edit input selections and how they are mapped.
Formats: select the framebuffer primary video format, any secondary.
formats, and parameters of up/down/crossconversion for input/output.
Digital Out: assign outputs either Primary or Secondary formats.
Analog Out: configure the component/composite +Y/C analog output.
HDMI: configure the HDMI input and output
Control: configures Io HD default output (test pattern, pass through, desktop,
etc.) plus setting genlock and output timing.
Setup: configures Video and Audio options such as composite black level and
analog audio monitor level.
Codec: used to select codec options such as whether paused video appears as a full
frame or a single field (jitter shown or not shown) and 24 to 30 fps padding
patterns.
Timecode: monitor RP-188 timecode and configure timecode window burn
output (Note: SMPTE 12M-2 is the updated name and specification for what
was RP-188)
Timelapse: enables the capture of select frames over a specified time interval.
Info: displays status information about the Io HD. This information is generally
intended for troubleshooting and support.