User`s guide

Xserve Take Apart - 37
ATA Controller Board
Procedure
1. Disconnect the blower cable nearest the ATA controller board.
2. Press in on both ends of the clip securing the right side of the ATA controller board and
remove the clip from the server. Repeat for the clip on the left side of the board.
3. Lift the ATA controller board straight up to disconnect it from the drive interconnect and
logic boards and remove the board from the server.
Note: When replacing the ATA controller board, align it over the two pairs of connectors on
the drive interconnect and logic boards, making sure the “MLB” arrow printed on it points
toward the logic board, and press down.