User Guide

Chapter 29 Ultrabeat 599
Entering Offsets
By clicking in the parameter offset row you select the step into which you would like to
enter a value. Every following parameter change made in the Synthesizer section will
be recorded as an offset value for this step in the parameter offset row. To provide a
better overview, the parameter offsets in the Synthesizer section are displayed by a
yellow range of values. To enter an offset for a new parameter, click-drag on any yellow-
outlined parameter in the Synthesizer section.
Once a parameter offset has been created for a given parameter on a given step, this
will be represented in two ways. First, a yellow bar on the parameter will be drawn
from the original parameter to the new parameter. In the Parameter offset row, the
offset from the original parameter is represented as a yellow line starting from the zero
point and going up for positive offsets or down for negative offsets.
The Parameter Menu of the Parameter Offset Row
All parameters that have been changed in Step mode are automatically added to the
Parameter menu of the offset row. You can also select other parameters in the
Parameter menu to display their recorded offset values:
You can change these values in two different ways:
 By simply drawing with the mouse you can change or add parameter offset values.
 By clicking on a step in the parameter offset row and grabbing and moving the
corresponding control in the Synthesizer section, you can change the displayed
parameter offset value.