User Guide

598 Chapter 29 Ultrabeat
All parameters you automate will show up in the pop-up menu at the top of the
Parameter offset row (see “The Parameter Offset Row” below).
When you engage Step mode, Ultrabeat’s interface changes in the following ways:
 Yellow frames appear around all parameters in the Synthesizer section that are
available for automation. Parameters not available for automation are still visible, but
are disabled.
 The Velocity/Gate row in the step grid changes to show the Parameter offset row.
The Parameter Offset Row
In this row you can view and enter offset values per step for any parameter in the
Synthesizer section framed in yellow. Editing parameters themselves is done, as before,
using the controls in the Synthesizer section. In addition, it is however possible to edit
offset values directly in the offset row.
Note: These have an effect only in relation to the actual parameter value. In other
words: a value entered into the parameter offset row will be either added to the value
set in the Synthesizer section (if the offset value is positive) or subtracted (if the offset
value is negative).
Parameter offset rowOffset menu