User Guide

506 Chapter 28 Sculpture
 Note + Sustain Pedal: Recording starts when the sustain pedal is depressed while a
note is held.
Recording is stopped by clicking the R(ecord) Enable button (or trigger) a second time.
Once all keys are released, and all voices have completed their decay phase, the
recording ends. You can stop recording early by releasing all keys, and then pressing a
single key.
Following the recording of a controller movement, R(ecord) Enable is automatically set
to off and Mode is set to Env only. This ensures that only the recorded movement will
be active, regardless of the stop position of the recorded controller.
Morph Envelope Parameters
The following section outlines the morph envelope’s parameters.
Mode
These buttons activate the morph envelope, and allow you to choose from the
following modes:
 Both buttons off: Morph functionality is disabled.
 Pad only: Envelope is deactivated, and morph functionality is controlled by the
morph cursor (the ball) or X/Y MIDI controllers only.
 Env only: Envelope is running, but the morph cursor and X/Y MIDI controllers are
deactivated.
 Env + Pad: Envelope is running, and the position of the morph cursor or X/Y MIDI
controllers is used as an offset for any envelope movements. In this mode (with both
the Pad and Env buttons activated), you can choose from the following setting by
clicking the offset label next to the mode buttons:
 Offset: The default mode, behavior is as described in the Env+Pad mode described
above).
 Point Set: Envelope is running. The selected envelope point can be edited by
moving the morph cursor in the pad or via MIDI (MorphX and MorphY Controller
Assignments).
 Point Solo: Envelope in a kind of “still picture” mode. The selected envelope point
can be edited by moving the morph cursor in the pad.