User Guide

490 Chapter 28 Sculpture
Waveform Menu
Allows you to choose the waveform used for vibrato, for example sine, triangle,
sawtooth, and so on.
There are two special rectangular waves: Rect01 and Rect1—the former switching
between values of 0.0 and 1.0 (unipolar), and the latter between values of –1.0 and +1.0
(bipolar, like the other waveforms). See “LFO 1 and 2” on page 486.
Curve
Allows you to define a freely-variable number of waveform variations, resulting in
subtle/drastic changes to your modulation waveforms.
The Curve parameter can even influence the Sine waveform type.
 Curve value of 0.0: Pure sine wave
 Curve values above 0.0: Wave is smoothly changed into a nearly rectangular wave.
 Curve values below 0.0: The slope at the zero crossing is reduced, resulting in shorter
soft pulses to +1 and –1.
Note: The waveform displayed between the Curve knob and the Waveform menu
shows the results of these two parameter settings.
Phase
Allows the choice between strictly monophonic or polyphonic vibrato with either
similar phases, completely random phase relationships, key-synced phase—or any
value in-between. See “LFO 1 and 2” on page 486, for more details.
Rate
Determines the rate of vibrato, which can be either synced to the current project
tempo or set independently in Hz (Hertz) values. See “LFO 1 and 2” on page 486, for
more details.
Depth via Vib Ctrl—Max
This slider determines the maximum possible modulation amount.
Depth via Vib Ctrl—Min
This slider determines the minimum possible modulation amount.