User Guide

Chapter 28 Sculpture 489
Target and Via Modulations
Two target modulation destinations can be assigned per LFO, with an optional,
additional via modulation. To activate, click on either the 1 or 2 buttons (which will
highlight the Target and “via“ menus), then choose the desired target from the Target
menu.
The “via” menus determine the source that controls the modulation scaling for each
LFO.
Modulation Amount Sliders: Amt and Via (Amount)
In cases where the via source is set to off, only one amount slider is visible (the “via
(amount)” slider is hidden):
 Amt 1/2: The Amt slider determines the modulation amount.
In cases where any via source other than off is selected, there are two sliders:
 Amt 1/2: The Amt slider determines the modulation amount in cases where the
incoming via signal is zero, for example a modulation wheel at its minimum position.
 Via (Amount) 1/2: The “via (amount)” slider determines the modulation amount in
cases where the incoming via signal is at full level, for example a modulation wheel
at its maximum position.
Vibrato
One LFO is hard-wired to pitch, for vibrato effects. The strength of the vibrato effect can
be adjusted via the MIDI controller assigned in the VibDepth Ctrl menu. This is set in
the MIDI Controller Assignment section. More information can be found in the “MIDI
Controller Assignments” on page 509.