User Guide

Chapter 28 Sculpture 479
In surround instances, the Xfeed control still controls the cross feedback between the
delay lines, but offers additional cross feed modes. You can access these in Sculpture’s
Extended Parameters section:
LoCut
Determines the cutoff frequency of the highpass filter at the delay line output/
feedback loop.
HiCut
Determines the cutoff frequency of the lowpass filter at the delay line output/feedback
loop.
Input Balance
This parameter allows you to move the stereo center of the Delay input to the left or
right, without the loss of any signal components. This makes it ideal for ping-pong
delays.
In surround instances, the parameter moves all channels towards the front left or front
right channel.
Delay Time
This parameter, coupled with the Sync setting, enables you to set the delay time. This
can be in either: musical note values—1/4, 1/4t (t = triplet), and so on—or in
milliseconds.
Sync
The Sync button allows you to select either tempo-synced, or tempo-independent
delay modes.
Output Width
This parameter allows a reduction of the stereo or surround base of the wet signal.
 A value of 0.0 results in mono output.
 A value of 1.0 results in full stereo or surround output (the left delay line output
channels are panned hard left, and the right delay line output channels are panned
hard right).
This parameter is used to achieve pure delay grooves, without hard left/right ping-
pong panning.