User Guide

478 Chapter 28 Sculpture
Velo Sens
Determines the velocity sensitivity of the cutoff frequency. The harder you strike the
keyboard you’re playing, the higher the cutoff frequency (and generally, the brightness
of the sound) becomes.
 A value of 0.0 disables velocity sensitivity.
 A value of 1.0 results in maximum velocity sensitivity.
Post Processing
The post processing tools covered in this section impact on the summed signal of all
voices, rather than on a per-voice basis.
Delay
This is a (project) tempo-syncable stereo or true surround delay. It may also be set to
run freely (not synchronized). The Delay section features all the general delay
parameters you’d expect from a delay plus the Groove (delay timing) Pad.
General Delay Parameters
The following section covers the general parameters of the Delay section.
On/Off
The Delay button enables or disables the Delay section.
Wet Level
The Wet Level knob sets the level of the Delay output (wet signal). The parameter value
is expressed as a percentage (%).
Feedback
Defines the amount of delay signal that is routed back from the output channels (of
the delay unit) to the input channels (of the delay unit). Negative values result in
phase-inverted feedback.
Xfeed (Crossfeed)
As above, but this parameter defines the amount of delay signal that is fed from the
left out to right in and right out to left in (of the delay unit). Negative values result in
phase-inverted feedback of the crossfed signal.