User Guide

438 Chapter 25 EXS24 mkII

To use the Sample Editor Loop commands:

1 Choose either of the selection commands in the Edit menu of the Sample Editor:

Â Sample Loop → Selection: The loop area (defined by the Loop Start and End points)

is used to select a portion of the overall audio file.

Â Selection → Sample Loop: The selected area is used to set the Loop Start and End

points.

2 Once you’ve selected the desired area using either of the commands above, choose

Edit > Write Sample Loop to Audio File.

The new loop values will be written to the audio file header.

Setting Group Parameters

Groups offer several parameters for simultaneous control over all assigned zones.

Key Range

The two key range parameters allow you to define a key range for the group.

Â Lo(w): Sets the lowest note at which the group will sound

Â Hi(gh): Sets the highest note at which the group will sound.

Playing notes outside this range will not trigger the zones assigned to this group.