User Guide

Chapter 2 Delay 39
Editing the Pan Parameter in the Tap Display
The way that the Pan parameter is represented in the Pan view is entirely dependent
on the input channel configuration of Delay Designer.
In mono input/stereo output configurations, all taps are initially panned to the center.
To edit the pan position, click-drag (vertically) from the center of the tap—in the
direction you wish to pan the tap or taps. A white line will extend from the center in
the direction you have dragged, reflecting the pan position of the tap (or taps, in
multiple selections). Lines above the center position indicate panning to the left, and
lines below the center position, panning to the right.
With stereo input/stereo output configurations, the Pan parameter adjusts the stereo
balance, not the position of the tap in the stereo field. The Pan parameter takes the
form of a stereo balance dot on the tap representing its stereo balance. To adjust the
balance, click-drag the stereo balance dot up or down the tap.