User Guide

Chapter 2 Delay 31
Note: The Autozoom button needs to be turned off for this to work. When you zoom in
on a small group of taps, the overview display continues to show all taps. The area
shown in the Tap display is indicated by the bright rectangle.
To move to different sections of the Tap display:
m Click-hold the bright rectangle and drag to the left or right.
The zoomed view in the main display will update as you drag.
Creating and Deleting Taps
You can create new delay taps in three different ways: the identification bar, by using
the Tap pads, or by copying existing taps.
To create taps in the identification bar:
m Click at the desired position.
To create taps with the Tap pad:
1 Click the upper Start pad.
Note: Whenever you click the Start pad, it will automatically erase all existing taps.
Given this behavior, once you have created your initial taps, you will want to create
subsequent taps by clicking in the identification bar.
The upper pad label will change to Tap, and a red tap recording bar will appear in the
strip below the view buttons.
2 Click the Tap button to record new taps on the fly.
New taps are created (at the exact moments in time) of each click, adopting the
rhythm of your click pattern.