User Guide

282 Chapter 21 ES2
RndN02
RndNO2 (Note On Random2) behaves like Note On Random1 with the exception that it
glides to the new random value using the Glide time (inclusive of modulation). It also
differs from NoteOnRandom1 in that the (random modulation) value changes when
playing legato, while in legato mode.
SideCh
SideCh (Side Chain modulation) uses a Side Chain (tracks, inputs, busses) to create a
modulation signal. The Side Chain source can be selected in the upper gray area of the
window. It is fed to the internal envelope follower, which creates a modulation value
based on the current Side Chain input signal level.
Via—Controlling the Modulation Intensity
Some modulation sources are unipolar, delivering values between 0 and 1. Others are
bipolar, and output values between –1 and +1. The following sources may be used to
modulate the modulation intensity.
LFO1
The modulation undulates at the speed and waveform of LFO1, which controls the
modulation intensity.
LFO2
The modulation undulates at the speed and waveform of LFO2, which controls the
modulation intensity.
ENV1
ENV1 controls the modulation intensity.
ENV2
ENV2 controls the modulation intensity.
ENV3
ENV3 (the level envelope) controls the modulation intensity.
Pad-X, Pad-Y
Both axes of the Square (the vector envelope) are available as via sources as well,
enabling you to control modulation intensities with them.
Kybd
Kybd (Keyboard) outputs the keyboard position (the MIDI note number). The center
point is C3 (an output value of 0). Five octaves below and above, an output value of –1
or +1, respectively is sent.