User Guide

276 Chapter 21 ES2
SineLevl
SineLevl (Sine Level) allows modulation of the sine wave level of Oscillator 1, which can
be mixed directly into the input of the dynamic stage—without being affected by the
filters. The parameter defines the level of the first partial tone of Oscillator 1. See “Sine
Level” on page 271.
OscLScle
OscLScle (Osc Level Scale) allows modulation of the levels of all three oscillators
simultaneously. A modulation value of 0 mutes all oscillators, while a value of 1 raises
the gain of the entire mix by 12 dB. The modulation is applied before the overdrive
stage, allowing for dynamic distortions.
Osc1Levl
Osc1Levl (Osc 1 Level) allows modulation of Oscillator 1’s level.
Osc2Levl
Osc2Levl (Osc 2Level) allows modulation of Oscillator 2’s level.
Osc3Levl
Osc3Levl (Osc 3Level) allows modulation of Oscillator 3’s level.
Cutoff 1
This target allows modulation of the Cutoff Frequency of Filter 1. See “Cutoff and
Resonance” on page 266.
Resonance 1 (Reso 1)
This target allows modulation of the Resonance of Filter 1. See “Cutoff and Resonance”
on page 266.
Cutoff 2
This target allows modulation of the Cutoff Frequency of Filter 2.
Resonance 2 (Reso2)
This target allows modulation of the Resonance of Filter 2.
LPF FM
A sine signal, at the same frequency as Oscillator 1, can modulate the Cutoff frequency
of Filter 2 (which always works as a lowpass filter). LPF FM (Lowpass Filter Frequency
Modulation) allows the modulation of Filter 2’s FM modulation intensity. This filter FM
parameter is described in “Filter 2 FM” on page 269.
Cut 1+2
Cut 1+2 (Cutoff 1 and 2) modulates both filter’s Cutoff frequencies in parallel, much like
applying the same modulation to Cutoff 1 and Cutoff 2 in two Router channels.