User Guide

Chapter 14 Utility 203
 Sine Sweep button: Activate to generate a user-defined frequency spectrum sine wave
sweep.
 Time field: Determines the duration of the sweep.
 Start Freq and End Freq fields: Define the oscillator frequency at the beginning and
end of the sine sweep.
 Sweep Mode (extended parameter): Choose either a Linear or Logarithmic sweep
curve.
 Trigger button: Click to trigger the sine sweep. The behavior of the Trigger button can
be switched via the menu below:
 Single: Clicking the Trigger button triggers the sweep once.
 Continuous: Clicking the Trigger button triggers the sweep indefinitely.
Using the Test Oscillator
If you insert the Test Oscillator into an Insert slot of an audio channel, you must pass
audio through this channel, in order to generate a signal.
To use the Test Oscillator in an audio channel’s Insert slot:
1 Place any audio region onto a track.
2 Insert the Test Oscillator into this track’s channel, and start playback.
You can also insert the Test Oscillator plug-in in the Instrument slot of instrument
channel strips. The Test Oscillator starts generating the test signal as soon as it is
inserted. You can switch it off by bypassing it.