User Guide

Chapter 12 Convolution Reverb: Space Designer 189
 Drag any band to the right or left to adjust its frequency.
 Drag any band up to increase the Gain, down to lower the Gain.
 Position the mouse pointer directly on the (illuminated) pivot point of a parametric
band and drag up to raise the Q or down to lower the Q.
Automating Space Designer
Space Designer cannot be fully automated as per most other Logic Studio plug-ins. This
is because Space Designer needs to reload the impulse response (and recalculate the
convolution) before audio can be routed through it.
You can, however, record, edit, and play back any movement of the following Space
Designer parameters:
 Stereo Crossfeed
 Direct Output
 Reverb Output