User Guide

Chapter 12 Convolution Reverb: Space Designer 175
 Latency Compensation button: Switches Space Designer’s internal latency
compensation feature on or off. See “Latency Compensation” on page 177 for more
information.
 Definition area: Lets you configure Space Designer to switch to a less defined IR set in
order to emulate reverb diffusion and save CPU. See “Definition” on page 177 for
more information.
 Rev Vol Compensation: Engages Space Designer’s internal IR volume matching (see
“Rev Vol Compensation” on page 177 for more information).
 Output sliders: Adjust output levels (see “Output Parameters” for more information).
The lower (flat) section of Space Designer contains the following global parameters:
 Filter parameters: Activate, adjust the resonance, and select the mode of Space
Designer’s resonant filter. See “Filter Parameters” on page 184 for more information.
 Pre-Dly knob: Sets the reverb’s predelay time, or time between the original signal and
the first reflections from the reverb. See “Pre-Dly (Predelay)” on page 179 for more
information.
 IR Start knob: Shifts the point at which the impulse response will play back. See “IR
Start” on page 180 for more information.
 Spread knob: For synthesized impulse responses, this adjusts the perceived stereo
width (for stereo instances of Space Designer) or surround width (for surround
instances) to widen the perceived stereo or surround field and enhance the stereo or
surround effect. See “Spread Parameters” on page 187 for more information.
 Xover knob: Sets the crossover frequency below which synthesized IRs will be
processed by the Spread knob. See “Spread Parameters” on page 187 for more
information.