Instruments and Effects
Table Of Contents
- Logic Studio Instruments and Effects
- Contents
- Introduction to the Logic Studio Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Convolution Reverb: Space Designer
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EVB3
- EVD6
- EVP88
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Sculpture
- The Synthesis Core of Sculpture
- Sculpture’s Parameters
- Programming: Quick Start Guide
- Programming: In Depth
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
Chapter 2 Delay 37
If you have multiple taps selected, the values of all selected taps will be increased or
decreased relative to other taps.
You can also set the value of multiple taps by Command-dragging horizontally and
vertically across several taps in the Tap display. As you do so, the parameter value
changes to match the mouse position as you drag across the taps. Put another way,
Command-dragging across several taps allows you to “draw” in values, much like
drawing in controllers with the Pencil tool in the Hyper Editor.
You can also hold down the Command key, and click the Tap display before dragging.
This will result in a line trailing behind the pointer. The values of the taps are aligned
along the line when you click the Tap display again.
Option-clicking a tap resets the chosen parameter to its default setting. If multiple taps
are selected, Option-clicking one tap will reset that parameter to its default value for all
selected taps.