Instruments and Effects
Table Of Contents
- Logic Studio Instruments and Effects
- Contents
- Introduction to the Logic Studio Plugins
- Amp Modeling
- Delay
- Distortion
- Dynamics
- EQ
- Filter
- Imaging
- Metering
- Modulation
- Pitch
- Reverb
- Convolution Reverb: Space Designer
- Specialized
- Utility
- EVOC 20 PolySynth
- EFM1
- ES E
- ES M
- ES P
- ES1
- ES2
- The ES2 Parameters
- Tutorials
- Sound Workshop
- Sound Design From Scratch, Filter Settings, Digiwaves
- Three Detuned Sawtooth Oscillators and Unison Mode
- Extremely Detuned Monophonic Analog Sounds, Effects
- Clean Bass Settings With One Oscillator Only
- Distorted Analog Basses
- FM Intensity and Frequency
- Controlling FM Intensity by an Envelope and FM Scaling
- FM With Drive and Filter-FM
- FM With Digiwaves
- FM With Wavetables
- Distorted FM in Monophonic Unison
- FM With Unusual Spectra
- Slow and Fast Pulse Width Modulations With Oscillator 2
- Pulse Width Modulation With Two Oscillators, PWM Strings
- Ring Modulation
- Oscillator Synchronization
- First Steps in Vector Synthesis
- Vector Synthesis—XY Pad
- Vector Synthesis Loops
- Bass Drum With Self-Oscillating Filter and Vector Envelope
- Percussive Synthesizers and Basses With Two Filter Decay Phases
- Templates for the ES2
- Sound Workshop
- EVB3
- EVD6
- EVP88
- EXS24 mkII
- Learning About Sampler Instruments
- Loading Sampler Instruments
- Working With Sampler Instrument Settings
- Managing Sampler Instruments
- Searching for Sampler Instruments
- Importing Sampler Instruments
- Parameters Window
- The Instrument Editor
- Setting Sampler Preferences
- Configuring Virtual Memory
- Using the VSL Performance Tool
- External Instrument
- Klopfgeist
- Sculpture
- The Synthesis Core of Sculpture
- Sculpture’s Parameters
- Programming: Quick Start Guide
- Programming: In Depth
- Ultrabeat
- GarageBand Instruments
- Synthesizer Basics
- Glossary
- Index
104 Chapter 6 Filter
EVOC 20 Filterbank Parameters
The EVOC 20 Filterbank window is divided into three main sections: the Formant Filter
section in the center of the window, the Modulation section at the bottom center, and
Output section along the right side.
Formant Filter Section
The parameters in this section control the frequency bands in the two filter
banks: Filter Bank A and Filter Bank B.
 Frequency band faders: Set the volume of each frequency band in Filter Bank A using
the upper (blue) faders, and set the volume of each frequency band in Filter Bank B
using the lower (green) faders.
You can easily create complex bar curves by dragging horizontally across either row
of faders. This method makes editing multiple frequency band levels quick and
convenient.
 Frequency bar and fields: The blue bar above the upper row of faders controls the
overall frequency range for both filter banks. Drag the bar to move the entire
frequency range, drag the left end to move only the lower frequency (between 75
and 750 Hz), or drag the right end to move only the upper frequency (between 800
and 8000 Hz). You can also edit the numerical values above the bar directly (between
80 and 8000 Hz).