X

Chapter 16 Mix a project 515
Dene a channel strip’s stereo output
In Logic Pro, you can choose the physical output pair on which the stereo output is played. By
default, it’s played on Stereo Output (Output 1-2). However, you can easily change the stereo
output preference—if you’re exchanging projects with another studio that uses a dierent
output pair, for example.
You can also dene the output pair for individual channel strips in the Mixer.
Dene the stereo output for a channel strip
1 Choose Logic Pro > Preferences > Audio.
2 Click the I/O Assignments tab, then the Output tab.
3 Choose an output pair from the Output pop-up menu in the Stereo section.
The Mirroring checkbox becomes available for all chosen output pairs, with the exception of
Output 1-2.
4 Do one of the following:
•
Deselect the Mirroring checkbox to have the output signal routed to the chosen output pair
(Output 3-4, for example).
•
Select the Mirroring checkbox to have the output signal routed to the chosen output pair
(Output 3-4, for example), as well as to the physical outputs (Output 1-2). This is useful when
feeding the signal to a second pair of monitors, for example.
Dene the output pair for a channel strip
m Click-hold the channel strip’s Output slot, then choose an output pair from the pop-up menu.
Dene a channel strip’s mono output
You can dene a channel strip’s mono output setting directly from the channel strip’s
Output slot.
Dene the mono output for a channel strip
m Click-hold the channel strip’s Output slot, then choose a mono output from the pop-up menu.