7.2.1

68 Chapter2LogicControl

Toremoveaninstrument:
1 Pre-selectthe“--”value(byturningtheV-Potfullycounter-clockwise)
2 PresstheV-Selectbutton.
LogicControlwillnotswitchtoInstrumentEditview,andnoPlug-inwindowwillbe
launched.Ifonewaspreviouslyopened,itwillbeclosed.
InstrumentEditView
 ThemodedisplaywillshowIn.
 DependentontheNAME/VALUEbutton,theLCDchangesinthefollowingwa ys:
 Name—TheupperLCDrowshowsthetrack’sname,instrumentname,current
parameterpageandtotalnumberofparameterpages.ThelowerLCDrowshows
thenameoftheparameterthatcanbeeditedwiththeV-Potdirectlybelowit.
 Value—TheupperLCDrowshowsthenameoftheparameterthatcanbeedited
withtheV-Potbelowit.ThelowerLCDrowshowsthecurrentvalueofthe
parameterbeingedited.IfthereissufficientspaceontheLCDrow,theunittypeis
shownafterthevalue.Example:Hz.
 TurningaV-Potchangesthecorrespondingparameter.
 PressingaV-Selectsetstheparametertoitsdefaultvalue,exceptwherethe
parameteronlyhastwovalues(on/off,forexample).Inthiscase,pressingtheV-
Selectswitchesbetweenthesevalues.
Compatibility
LogicControlcaneditallinstrumentsthatcanbeautomated.Theplug-intype(Logic
native,TDM,AudioUnits)isirrelevant.
Somethird-partymanufacturerinstrumentsunfortunatelydon’tprovideparameter
namesand/orvaluesastext.Insuchcases,parametersareenumeratedas“Control#1,”
“Control#2,”andsoon,withvaluesdisplayedasnumbersrangingbetween0and1000.
Pleasecontacttheplug-inmanufacturertoobtainaversionwhichsupportsthis
feature.