7.2.1

Chapter1ControlSurfaceSetup 31

 Multiply,withshor tcutsfor+1and–1(–1fordecrementing).
Note:FordetailsontheabovementionedAssignmentparametersread“Assignment
Parameters”onpage35.Forafullviewofallparameters,enabletheExpertView
option.
ShortcutsforDefiningMultipleAssignments
IfyouwanttodefinemultipleassignmentsintheControllerAssignmentEditor,youcan
usethefollowingshortcuts:
Scenario1:assignfaders1to16tovolumeoftracks1to16
1 Learnvolumetrack1forfader1.
2 Learnvolumetrack16forfader16.
3 Asthetrack“distance”(15)isthesameasthecontrollernumberdistanceforthetwo
mostrecentlylearnedassignments,a“Doyouwanttofillupinbetween?”message
appears.SelectOKtoautomaticallyfillthefaderswithcorrespondingVolume
assignmentsforeachtrack.
Note:Thisfeaturealsoworksforanyothertrackparameter(Pan,Solo,Mute,andsoon).
Scenario2:assignknobs1to16toplug-inparameters1to16
1 Learnparameter1forknob1.
2 Learnparameter16forknob16.
Note:TheparameterenumerationisshowninthePlug-inwindow’sControlView.
3 Asthegapbetweenparameternumbers(15)isthesameasthegapbetweencontroller
numbersforthetwomostrecentlylearnedassignments,a“Doyouwanttofillupin
between?”messageappears.SelectOKtoautomaticallyfilltheknobswith
correspondingParameterassignmentsforeach.
Note:Thisfeaturealsoworksforinstrumentparameters.Currently,thisonlyworksfor
knobsthatsendasinglechannelmessage,wherethefirstdatabyteisthecontroller
numberandtheseconddatabyteisthevalue.Alternatively,thecontrollernumbercan
beencodedintheMIDIchannel,withafixedfirstdatabyte.
Zones,Modes,andAssignments
Youcandefine“groups”ofcontrolsonacontrolsurfacethatcanbeswitchedbetween
differentoperatingmodes.Asanexample,theLogicControlrotaryencoderscanbe
usedtocontrolPan,SendLevelorplug-inparameters.
Such“groups”arecalledZones.Thedifferentoperationsthatcanbeperformedwithina
ZonearecalledModes.
AZonecontainsoneormoreModes,oneofwhichistheactiveMode.AZonemayalso
containmodelessassignments—assignmentswhicharealwaysactive.