7.2.1

Chapter1ControlSurfaceSetup 23

EQParameterPage
TheEQParameterPageparameterdefinestheEQparameterdisplayedintheEQ
ChannelStripView.
Toexplain:TheChannelandLinearPhaseEQsfeature8bandsperaudiochannel,with
eachbandofferingfourparameters.Alloftheseparameterscanbeaccessedwithyour
controlsurface.
IfyouuseacontrolsurfacethatdoesnotdisplayallEQparametersatonce,youneed
tostepthroughtheparameter“pages.”Asanexample:Imagineyouareusinganeight
channelcontrolsurface.Youcandirectlyaffectparameters1to8withknobs/sliders1
to8—onceyou’veswitchedtoEQChannelStripEditView.Youthenneedtoswitchby
a“page”toaccessparameters9to16.
Send/Plug-inParameters
Theseparametersdefinehowyourcontrolsurfacecontrolssendandplug-in
parameters.
SendSlot
TheSendSlotparameterdeterminesthecurrentlyselectedSendslot.Normally,avalue
of1wouldbeused,asthisaccessesthefirst(top)Sendoneachchannel.Avalueof2
accessesthesecondSend,andsoon,toSend8.TheSendslotsareaccessedby
pressingtheUp/Downbuttonsonyourcontrolsur face—ifapplicable.
SendParameter
DefinestheSendparameter(tobeeditedwiththeencoders)whenintheSendMulti
Channelview:
 Destination:—encoderisusedtodeterminethebuschannelnumberfortheSend
slot.
 Level—encoderisusedtoadjusttheSendlevel.
 Position—encoderssetPreorPostfadermodes.
 Mute—encodersmute/unmutetheselectedSendslot.
SendParameterPage
MuchliketheEQparameters,upto32parametersareavailableinSendChannelStrip
Viewforagivenchannel(EightSendslotsmultipliedbythefourparameterslisted
above).SendParameterPagedeterminesthecurrentpagefortheseparameters.
Split:no.ofupperparameters
Controlsurfacesthatsupportsplitmodeallowthedisplayoftwoseparateparameter
sectionswithinoneplug-in(orevendifferentplug-ins).TheyarecalledSplitUpperand
SplitLower .