7.2.1

146 Chapter9KorgmicroKONTROLandKONTROL49

TheLCDbacklightisredwhilerecording,andgreenatothertimes.
Thecontrolsinthemainsectionhavethefollowingmeaning:
ChannelStrips
Thereareseveralmodesfortheencoders,enabledwithSCENEandPad9–16.
ExternalInput
Control Assignment
Mainencoder ControlsSPLinoneofthreemodes(seePads1–3in“TransportMode”on
page144).
SETTING Held down in Send mode:
 Mainencoderchoosescurrentsend.
 Padshavespecialmeaning—see“SendMode”onpage145.
 LCDsdisplaysenddestinations.
 Encoderschoosesenddestinations.
Holding down in Plug-in Edit mode:
 Mainencoderchoosescurrentplug-ininsert.
 Padshavespecialmeaning—see“Plug-inEditoverlay”onpage145.
 LCDsdisplayplug-innameoftheeighttracks.
MESSAGE Enables/DisablesFlipmode.Whenenabled,theencoderscontrolvolumeand
thefaderscontroltheparameterdisplayedintheLCDs.
SCENE Whilehelddown,padsswitchPadandChannelStripmodes.See“Pads”on
page143.
EXIT —
HEXLOCK Shiftsfaderbanktothepreviouseighttracks(LEDisonifprevioustracksexist).
ENTER Shiftsfaderbanktothenexteighttracks(LEDisonifsubsequenttracksexist).
<OctaveShiftDown
>OctaveShiftUp
Control Assignment
LCD Shows the parameter controlled by the encoder. The currently chosen value is
displayed for a few seconds while operating an encoder or fader.
When the encoders are in a multi-channel view (Pan, Send, Send Setup), the
background color indicates the track’s automation mode:
 green—offorRead
 yellow—TouchorLatch
 red—WriteorMIDI
Encoder ControlstheparametershowndirectlyabovetheencoderintheLCD.
Fader Controlsvolume.Asthefadersdon’tofferfeedback,“Pickupmode”isusedif
enabledintheLogicPreferences.Thismeansthattheywillnot“takeover”until
NULLed.
Control Assignment
FootSwitch Startsandstopsplayback.
Pedal Controlsmastervolume.