X

Chapter 13 Sculpture 255
•
Resonance knob (morphable): Rotate to set the lter resonance value.
•
In highpass and lowpass modes, Resonance emphasizes the portions of the signal that
surround the center frequency.
•
In Peak, Bandpass, and Notch modes, Resonance controls the width of the band that
surrounds the center frequency.
•
Key (tracking) knob: Rotate to determine how cuto frequency responds to key position. The
farther up or down the keyboard you play, the more bright or mellow the sound becomes.
Technically speaking, the cuto frequency is modulated by the keyboard position. A value of
0.0 disables key tracking. A value of 1.0 makes the cuto frequency follow the fundamental of
the note across the entire keyboard range. Play an octave higher and the cuto frequency also
changes by an octave.
•
Velo Sens knob: Rotate to determine how cuto frequency responds to incoming note
velocities. The harder you strike the keyboard, the higher the cuto frequency—and, generally,
the brightness of the sound—becomes. A value of 0.0 disables velocity sensitivity. A value of
1.0 results in maximum velocity sensitivity.
Sculpture delay eect parameters
Sculpture delay eect overview
This is a (project) tempo-syncable stereo or true surround delay. It can also run freely
(unsynchronized). The Delay section features all the general delay parameters you’d expect from
a delay plus the Groove (delay timing) Pad.
LoCut/HiCut sliders
Groove pad
Output Width slider
Delay Time slider
Sync button
Feedback knob
Delay on/off button Wet Level knob
Xfeed knob
Input Balance
slider
Delay eect parameters
•
Delay On/O button: Turns the Delay eect on or o.
•
Wet Level knob: Rotate to set the Delay output level.
•
Feedback knob: Rotate to set the amount of delay signal that is routed back from the
delay unit output channels to the delay unit input channels. Negative values result in
phase-inverted feedback.
•
Xfeed (Crossfeed) knob: Rotate to set the amount of delay signal that is fed from the delay unit’s
left output channel to the right input channel and vice versa. Negative values result in phase-
inverted feedback of the crossfed signal.
In surround instances, the Xfeed knob controls crossfeedback between the delay lines,
but oers additional crossfeed modes. You can access these in Sculpture’s Extended
Parameters area.