X

Chapter 9 EXS24 mkII 198
Make advanced EXS24 mkII group selections
You can dene a specic event to use as a group selection switch. Whenever the dened
selection event is triggered, zones pointing to this group can be played, while other groups
selected with a dierent event are not played. The dened event does not play or alter a sound; it
acts only as a group selection switch.
The Select Group By command is available in the View menu when you are in Groups view.
Group selection lters
The following group selection lters are available in the Type column pop-up menu:
•
Note: Used to select a group by MIDI note. You need to assign multiple groups to a dierent
MIDI note; if the note is triggered, playback of the other group is stopped.
•
Group: Used to select a group based on membership of a master group. You need to assign
multiple groups to one master group; if any group member within the master group is
triggered, playback of the other group or groups is stopped.
•
Control: Used to select a group based on a specied controller number.
•
Bend: Used to select a group by bend range. Groups are played only if they fall within the
specied bend range.
•
MIDI Channel: Used to select a group by MIDI channel. Groups are played only if they match
the channel.
•
Articulation ID: Used to select a group based on the articulation ID. This parameter is available
as a modulation destination, so you can switch between sample groups with a controller. For
example, you could use your keyboard modulation wheel to switch between several hi-hat
groups with dierent opening degrees.
•
Tempo: Used to select a group by tempo. Groups are played only if they fall within the
specied tempo range.