X

Chapter 9 EXS24 mkII 179
Create a modulation routing that includes a via source
1 Choose the target parameter you want to modulate from the Dest pop-up menu.
Click here to choose a
modulation source.
Click here to choose a
modulation destination.
2 Choose a modulation source from the Src pop-up menu.
3 Choose the modulation source that you want to use for control of modulation intensity from the
via pop-up menu.
4 Vertically drag the upper intensity slider to set the maximum modulation intensity.
5 Vertically drag the lower intensity slider to set the minimum modulation intensity.
Move the entire via range
m Vertically drag the area between the two intensity slider halves (the range).
Both arrowheads move simultaneously.
Tip: If this area is too small to drag, just drag an unused section of the intensity slider to move
the area.