X

Chapter 8 EVOC 20 PolySynth 149
EVOC 20 PolySynth output parameters
The Output section provides control over the type of signal, stereo width, and level of signal that
is sent from EVOC 20 PolySynth. The Output section also has an ensemble eect processor.
Output parameters
•
Signal pop-up menu: Choose the signal that is sent to the EVOC 20 PolySynth main outputs.
•
Voc(oder): Choose to hear the vocoder eect.
•
Syn(thesis): Choose to hear only the synthesizer signal.
•
Ana(lysis): Choose to hear only the analysis signal.
Note: The last two settings are mainly useful for monitoring purposes.
•
Ensemble buttons: Turn the ensemble eect on or o and determine the type of sound.
•
O: Click to turn the ensemble eect o.
•
I: Click to obtain a special chorus eect.
•
II: Click to obtain a fuller and richer sound.
•
Level slider: Drag to set the overall volume of the EVOC 20 PolySynth output signal.
•
Stereo Width knob: Rotate to distribute the output signals of the Synthesis section lter bands
in the stereo eld.
•
At the 0 position to the left, the outputs of all bands are centered.
•
At the centered position, the outputs of all bands ascend from left to right.
•
At the Full position to the right, the bands are output—alternately—to the left and
right channels.