X

Chapter 7 ES P 132
ES P envelope and level controls
ES P features an ADSR envelope that aects both the lter cuto (ADSR Int) and the level of the
sound over time. This section also covers the master level control parameters.
Envelope and level parameters
•
Attack slider: Move to set the time it takes for the signal to reach the initial, desired signal level
(the sustain level).
•
Decay slider: Move to set the time it takes for the signal to fall from the attack level to the
sustain level.
•
Sustain slider: Move to set the signal level (the sustain level).
•
Release slider: Move to set the time it takes for the signal to fall from the sustain level to a level
of zero.
•
Volume knob: Rotate to set the overall ES P output level.
•
Velo Volume knob: Rotate to set the amount (depth) of velocity sensitivity to incoming MIDI
note events. When set to higher values, each note is louder if struck harder. At lower values, the
dynamic response is reduced, so that there is little dierence when you play a note pianissimo
(soft) or forte (loud/hard).
•
VCA Mode buttons (Controls view): Click ADSR to control the amplier with the ADSR envelope
generator. Click Gate to output a constant organ-like tone when a key is played.