9

AssignmentControl
Controls Surround Y.Encoder 6 (AUX 6)
Controls the Slope parameter of band 1, if a Channel or Linear Phase
EQ is inserted.
Encoder 11 (GAIN 1)
Controls the Frequency parameter of band 1, if a Channel or Linear
Phase EQ is inserted.
Encoder 12 (FREQ 1)
Controls the Q factor of band 1, if a Channel or Linear Phase EQ is
inserted.
Encoder 13 (Q 1)
Controls the Gain parameter of band 2, if a Channel or Linear Phase
EQ is inserted.
Encoder 14 (GAIN 2)
Controls the Frequency parameter of band 2, if a Channel or Linear
Phase EQ is inserted.
Encoder 15 (FREQ 2)
Controls the Q factor of band 2, if a Channel or Linear Phase EQ is
inserted.
Encoder 16 (Q 2)
Controls the Gain parameter of band 7, if a Channel or Linear Phase
EQ is inserted.
Encoder 17 (GAIN 3)
Controls the Frequency parameter of band 7, if a Channel or Linear
Phase EQ is inserted.
Encoder 18 (FREQ 3)
Controls the Q factor of band 7, if a Channel or Linear Phase EQ is
inserted.
Encoder 19 (Q 3)
Controls the Slope parameter of band 8, if a Channel or Linear Phase
EQ is inserted.
Encoder 20 (GAIN 4)
Controls the Frequency parameter of band 8, if a Channel or Linear
Phase EQ is inserted.
Encoder 21 (FREQ 4)
Controls the Q factor of band 8, if a Channel or Linear Phase EQ is
inserted.
Encoder 22 (Q 4)
Controls Pan/Balance (of mono or stereo channels).Encoder 24 (PAN)
Tascam US-2400: Master Channel
The following table outlines the master channel strip controls and their assignments:
AssignmentControl
Selects Master Output channel strip if it exists; if
not, Output channel 1–2 is selected.
SEL
Disables Solo for all tracks/channels.CLR SOLO
Disables Mute for all tracks/channels.SHIFT
Disables the Record Enable buttons of all
tracks/channels.
F-KEY
Switches Flip mode between Off (LED off) and
Duplicate (LED on). In this mode, the fader of each
channel strip mirrors the encoder function.
FLIP
237Chapter 19 Tascam US-2400