9

Solo/Mute Mode
This mode is enabled by pressing SCENE and Pad 2.
AssignmentPad
Enables/disables Solo for the eight channels being controlled with
the eight channel strips.
1–8
Enables/disables Mute for the eight channels being controlled with
the eight channel strips.
9–16
Rec/Select Mode
This mode is enabled by pressing SCENE and Pad 3.
AssignmentPad
Activates/deactivates the Record Enable button of the eight channels
being controlled with the eight channel strips.
1–8
Selects one of the eight channels being controlled with the eight
channel strips.
9–16
User 4–8 Modes
These modes are enabled by pressing SCENE and Pad 4 to 8.
In these modes, the Pads are unassigned. Use the Learn function: Logic Pro > Preferences
> Control Surfaces > Learn Assignment for [function name] to assign them to key
commands, for example.
Note: When in Learn mode, if a pad is pressed and released immediately, the learned
assignment does not work as expected.
To successfully assign a key command
1 Enable the Learn New Assignment button in the Key Commands window.
2 Choose a key command, then press and hold down the pad, until the Learn New
Assignment button switches to the “up” state.
This slightly different approach is due to messages sent by the Korg devices: when the
pad is immediately released, a value range is learned. Holding the pad until Learn mode
disengages results in a fixed value being learned.
Send Mode
This mode is enabled by pressing SCENE and Pad 10. In Send mode, the channel strip
encoders control the send level of the selected send. The Pads remain in the currently
selected mode.
• Send Overlay: Pressing SETTING while the encoders are in Send mode changes the
operation of the Pads in Send mode.
169Chapter 11 Korg microKONTROL and KONTROL49