9

A pot’s current value is indicated by the NULL arrow LEDs.
• The Upper arrow is lit if the pot’s value is above the current value.
• The Lower arrow is lit if the pot’s value is below the current value.
• Both arrow LEDs are lit when the pot has reached the current value.
The pots can operate in one of three modes, with one sub-mode in each.
Note: If a modifier button, such as SHIFT, is shown below a description, it indicates that
the control has an alternate use while the modifier is held down.
Pan/Send Mode
Press F7 to enable Pan/Send mode (display shows “PA”). In this mode, the pots control
the following channel parameters:
AssignmentControl
Controls Send 1 level of selected channel.SEND A/P1
Controls Send 2 level of selected channel.SEND B/P2
Controls pan of selected channel.PAN/P3
Controls Send 3 level of selected channel.SEND C/P4
Controls Send 4 level of selected channel.SEND D/P5
Controls Send 5 level of selected channel.SEND E/P6
While SHIFT is held down (display shows “AS”), the pots allow you to perform the following
assignments:
AssignmentControl
Assigns Send 1 destination (bus) for selected channel.SEND A/P1
Assigns Send 2 destination for selected channel.SEND B/P2
Assigns input format of selected channel.PAN/P3
Assigns Send 3 destination for selected channel.SEND C/P4
Assigns Send 4 destination for selected channel.SEND D/P5
Assigns Send 5 destination for selected channel.SEND E/P6
Instrument Edit Mode
Press F8 to enter Instrument Edit mode (display shows “In”). The pots control (software)
instrument parameters.
Note: With SHIFT held down (display shows “b1”–“b9”), you can move between banks
(pages) of parameters. (See JLCooper CS-32 MiniDesk: Cursor Section.)
155Chapter 8 JLCooper CS-32 MiniDesk