9

• JLCooper CS-32 MiniDesk: Pots
• JLCooper CS-32 MiniDesk: Channel Strips
• JLCooper CS-32 MiniDesk: Bank Button
• JLCooper CS-32 MiniDesk: F Key Section
• JLCooper CS-32 MiniDesk: Cursor Section
• JLCooper CS-32 MiniDesk: Transport Section
• JLCooper CS-32 MiniDesk: Jog Wheel Section
JLCooper CS-32 MiniDesk: Display
The display shows information on the current mode, and parameters being edited.
MeaningDisplay text
A switching parameter (Solo, Mute, Rec/Rdy) has been disabled.--
Automation Enable setup: Mute buttons 1–6 display/set various
automation parameters.
AE
Pots (knobs) are in Pan/Send Assignment mode.AS
Pots are in Plug-in or Instrument Bank Select mode.b1—b9
Pots are in Instrument Edit mode.In
Mute buttons display/set Latch automation mode.Lt
Mute has been enabled.Mu
Pots are in Effect Edit mode.P1—P9
Pots are in Pan/Send mode.PA
Mute buttons display/set Read automation mode.rd
Rec/Rdy has been enabled.Re
Solo has been enabled.So
Mute buttons display/set Touch automation mode.Tc
Mute buttons display/set Write automation mode.Wr
When a channel is selected, the first two characters of its name are
briefly displayed.
Other text
While editing a numerical value with a fader or pot, the current
value is displayed. If there are more than two digits in the value,
the last two digits are shown. Plus/minus signs (+/–) are shown if
only one digit is displayed.
Numbers
JLCooper CS-32 MiniDesk: Pots
As the pots are not motorized, Pickup mode is used (if turned on in the Control Surfaces
preferences). In Pickup mode, the controller must reach (pick up) the current value before
the value starts to change. This prevents sudden jumps of parameter values caused by
playing back automation.
154 Chapter 8 JLCooper CS-32 MiniDesk