8

28 Chapter 1 Basic Control Surface Setup
 Full: Turning the encoder to the right sets the maximum value. Turning it to the left
sets the minimum value. The encoder also stops at its default value. As an example,
when the Pan knob is left of center, turning the encoder to the right initially sets
the Pan parameter to center (its default value). A further turn to the right sets the
Pan to full right (its maximum value).
 Fine: The parameter is incremented or decremented in fine steps—by one tick or
other unit. In this mode, the highest possible resolution is used. As an example;
when editing the Sample Delay plug-in’s Delay parameter: every encoder tick
increases or decreases the value by 1 sample, regardless of the resolution value.
 Mix Group value: Determines which group is edited when in Group Edit mode.
 Group Parameter Page: Defines which parameter of the edited group is assigned to
the left-most encoder.
How Control Surface Group Parameters Are Saved
Any changes to settings (in the Setup window or from the device) are saved in a
preferences file, named “com.apple.logic.pro.cs”, located in ~/Library/Preferences/Logic.
This file is saved independently from the Logic Pro Preferences file.