8

208 Chapter 17 Tascam US-2400
Instrument Edit View
In Instrument Edit view, the following AUX buttons have special assignments:
The AUX button LEDs show the currently selected parameter bank. AUX 2 LED is on if
parameters 25–48 are shown on the encoders.
Plug-in Edit View
In Plug-in Edit view, the following AUX buttons have special assignments:
The AUX button LEDs show the currently selected Insert slot. As an example: AUX 2
LED is on if Insert slot 2 is being edited.
Master Section
F-KEY Switches display of Hyper Editor:
 If Hyper Editor is open, it will be closed.
 If Hyper Editor is closed, it will be opened.
AUX 6 Switches encoders to Mixer view of Send 6 level.
F-KEY Switches display of Piano Roll Editor:
 If Piano Roll Editor is open, it will be closed.
 If Piano Roll Editor is closed, it will be opened.
Control Assignment
Control Assignment
AUX 1 Scrolls parameter fader bank left—by 24 parameters.
AUX 2 Scrolls parameter fader bank right—by 24 parameters.
AUX 4 Enables/Disables Bypass button of the instrument being edited.
Control Assignment
AUX 1 Scrolls parameter fader bank left—by 24 parameters.
AUX 2 Scrolls parameter fader bank right—by 24 parameters.
AUX 3 Increments Insert slot (chooses higher numbered slot).
AUX 4 Enables/Disables Bypass button of the plug-in being edited.
AUX 6 Decrements Insert slot (chooses lower numbered slot).
Control Assignment
MTR Switches encoder LED ring display between two modes:
 The value of the parameter (LED off).
 Level/peak hold meters (LED on).
In Level Meter mode, the LED below the encoder displays signal overloads
(clipping).
F-KEY Modifier key, used to switch the function of other controls (see “F-KEY” entries
in left column).
NULL Sets Surround x/y or Panning of selected channel to center position—LED is on
if Surround X (or Panning) is centered.