8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
206 Chapter 17 Tascam US-2400
In CHAN mode—with the SHIFT button held—the encoders control the following
parameters on the selected channel:
Control Assignment
Encoder 1 (AUX 1) Controls Pan/Surround Angle.
Encoder 2 (AUX 2) Controls Surround Radius.
Encoder 3 (AUX 3) Controls Surround LFE (level).
Encoder 4 (AUX 4) Controls Surround mode.
Encoder 5 (AUX 5) Controls Surround X.
Encoder 6 (AUX 6) Controls Surround Y.
Encoder 11 (GAIN 1) Controls the Slope parameter of band 1, if a Channel or Linear Phase EQ is
inserted.
Encoder 12 (FREQ 1) Controls the Frequency parameter of band 1, if a Channel or Linear Phase EQ is
inserted.
Encoder 13 (Q 1) Controls the Q factor of band 1, if a Channel or Linear Phase EQ is inserted.
Encoder 14 (GAIN 2) Controls the Gain parameter of band 2, if a Channel or Linear Phase EQ is
inserted.
Encoder 15 (FREQ 2) Controls the Frequency parameter of band 2, if a Channel or Linear Phase EQ is
inserted.
Encoder 16 (Q 2) Controls the Q factor of band 2, if a Channel or Linear Phase EQ is inserted.
Encoder 17 (GAIN 3) Controls the Gain parameter of band 7, if a Channel or Linear Phase EQ is
inserted.
Encoder 18 (FREQ 3) Controls the Frequency parameter of band 7, if a Channel or Linear Phase EQ is
inserted.
Encoder 19 (Q 3) Controls the Q factor of band 7, if a Channel or Linear Phase EQ is inserted.
Encoder 20 (GAIN 4) Controls the Slope parameter of band 8, if a Channel or Linear Phase EQ is
inserted.
Encoder 21 (FREQ 4) Controls the Frequency parameter of band 8, if a Channel or Linear Phase EQ is
inserted.
Encoder 22 (Q 4) Controls the Q factor of band 8, if a Channel or Linear Phase EQ is inserted.
Encoder 24 (PAN) Controls Pan/Balance (of mono or stereo channels).