8

17
203
17 Tascam US-2400
Setting Up Your Tascam US-2400
Please follow the steps outlined below to use your Tascam US-2400 with Logic Pro.
To set up the Tascam US-2400 for use with Logic Pro:
1 Make sure that your US-2400 units are connected to the computer via USB.
2 Ensure that the US-2400 is in native mode. Please consult your US-2400 manual for
more information on this.
3 Open Logic Pro.
Your control surfaces will be scanned for, and installed, automatically.
Special Note
The US-2400 is capable of running in both native and Mackie Control emulation modes.
If the unit is set up in Mackie Control emulation mode, and the native support plug-in
is installed in the Logic Pro program bundle, Logic Pro will detect: a US-2400 native
control surface and a Mackie Control, plus two Extender (XT) units.
If you want to run the US-2400 in Mackie Control mode, you should remove the
US-2400 plug-in from the Logic Pro application bundle. Logic Pro will then detect a
Mackie Control plus two Extender (XT) units (the appropriate setup for the US-2400 in
Mackie Control emulation mode), when you scan for control surfaces.
The Mackie Control differs in button layout to the Tascam US-2400. When running the
Tascam US-2400 in Mackie Control mode, certain controllers are not accessible (the
Joystick, as an example). Given these restrictions, use of the Tascam US-2400 in Mackie
Control mode is not recommended. If you choose to do so, please refer to the
documentation supplied with the Tascam US-2400 for details.