8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
198 Chapter 16 Tascam FW-1884
EQ Section (FW-1884 Only)
The EQ controls apply to a certain EQ band of the selected channel. A Channel or
Linear Phase EQ is automatically inserted in the channel, if not already present.
Mode Assignment
REC While held down, the SEL buttons activate/deactivate Record Enable for the
corresponding channel strip.
GAIN Edits the Gain of the currently selected EQ band.
SET Selects the channel input.
FREQ Edits the Frequency parameter of the currently selected EQ band.
SET Selects the channel output.
Q Edits the Q Factor of the currently selected EQ band.
SET Selects the channel input format.
HIGH Selects EQ band 6.
SHIFT Selects EQ band 8.
REC Switches the bypass state of EQ band 6 (driver version 1.20 or higher required).
HI-MID Selects EQ band 5.
SHIFT Selects EQ band 7.
REC Switches the bypass state of EQ band 7 (driver version 1.20 or higher required).
LOW-MID Selects EQ band 4.
SHIFT Selects EQ band 2.
REC Switches the bypass state of EQ band 3 (driver version 1.20 or higher required).
LOW Selects EQ band 3.
SHIFT Selects EQ band 1.
REC Switches the bypass state of EQ band 3 (driver version 1.20 or higher required).