8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 16 Tascam FW-1884 197
Channel Strips
UNDO Performs an Undo (of the last editing operation). The button LED is lit when a
Redo is possible.
SHIFT Performs a Redo (reverses an Undo operation).
SHIFT Modifier for other buttons.
CTRL Modifier for other buttons.
Control Assignment
Control Assignment
REC LEDs These LEDs are lit when the corresponding track/channel is recording. The
LEDs flash when the track/channel is in Record Enable mode (armed).
SEL Selects the track/channel.
SHIFT Enables/Disables Send mute, when encoders are controlling a Send level.
READ Sets the track automation mode to Read.
WRITE Sets the track automation mode to Write.
TCH Sets the track automation mode to Touch.
LATCH Sets the track automation mode to Latch.
SOLO Enables/Disables the Solo status of the track/channel.
SHIFT Disables Solo status for all tracks (driver version 1.20 or higher required).
MUTE Enables/Disables the Mute status of the track/channel.
SHIFT Disables Mute status for all tracks (driver version 1.20 or higher required).
Encoder Controls parameter chosen with the ENCODERS section.
SET When encoders are controlling a Send level, this combination allows you to set
the Send destination.
Fader Controls the channel volume.