8

196 Chapter 16 Tascam FW-1884
Assignment Overview
A modifier button (such as SHIFT) shown below a button description indicates that the
button has an alternate function/use, while holding down this modifier.
Note: The FE-8 units only offer the Channel Strip section, so other facilities mentioned
in this document don’t apply. The FW-1884 ENCODERS section is, however, applicable
to the FE-8 channel strips.
The FW-1082 has no channel encoders, and offers an extended channel strip section.
ENCODERS Section (FW-1884 Only)
SHORTCUTS Section (FW-1884 Only).
Control Assignment
FLIP Switches Flip mode between Off and Swap. In Swap mode, the parameter
controlled by the fader and encoder of each channel strip is swapped.
PAN Assigns Pan to encoders.
AUX 1 Assigns Send 1 level to encoders.
AUX 2 Assigns Send 2 level to encoders.
AUX 3 Assigns Send 3 level to encoders.
AUX 4 Assigns Send 4 level to encoders.
AUX 5 Assigns Send 5 level to encoders.
AUX 6 Assigns Send 6 level to encoders.
AUX 7 Assigns Send 7 level to encoders.
AUX 8 Assigns Send 8 level to encoders.
Control Assignment
SAVE/F1 Saves the active project. The button LED is lit when the project has been
edited since the last save operation.
REVERT/F2 Reverts to the most recently saved version of the project.
ALL SAFE/F3 Disables the Record Enable buttons of all channels.
CLR SOLO/F4 Switches Solo off for all channels.
SHIFT Switches Mute off for all channels.
MARKERS/F5 Creates a new marker at the current playhead position.
SHIFT Deletes the marker at the playhead position.
LOOP/F6 Enables/Disables Cycle mode.
CUT Cuts the current selection (of regions or events) and places it in the Clipboard.
DEL Deletes the current selection.
COPY Copies the current selection to the Clipboard.
PASTE Pastes the Clipboard contents to the current playhead position.
ALT/CMD Modifier for other buttons.