8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
16
195
16 Tascam FW-1884
Introduction
Logic Pro supports the Tascam FW-1884, FE-8 extension, and the FW-1082.
Version 1.10 (and higher) driver versions support the SoftLCD application which displays
information on track names, parameter assignments and current encoder values.
SoftLCD displays the current track automation mode when one of the automation
mode buttons is held down. The corresponding encoder edits the parameter.
Alerts are displayed in SoftLCD. Select buttons allow you to remotely-control alert
buttons.
The following text referring to the FW-1884 also applies to the FE-8 and FW-1082,
except where these devices are mentioned explicitly.
Setting Up Your Tascam FW-1884
The following section outlines the steps required to use your control surface with
Logic Pro.
To set up your Tascam FW-1884 control surface with Logic Pro:
1 Ensure that the appropriate FW-1884 driver software (for your version of Mac OS X) is
correctly installed. See the FW-1884 documentation for details. It may also be
worthwhile checking the manufacturer’s website.
2 Connect the FW-1884 to your computer with the supplied FireWire cable.
3 Open Logic Pro.
The FW-1884 is installed automatically.