8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
15
189
15 Roland SI-24
Setting Up Your Roland SI-24
Please follow these steps before using your control surface with Logic Pro.
To use the audio and MIDI facilities of the SI-24:
 Ensure that your SI-24 units are connected to the RPC card with the (included) cable.
This connector provides both digital audio and MIDI connections.
 Make sure that the appropriate driver software is installed, and functioning correctly.
Note: The RPC card is a PCI device, and is not compatible with (most) G5, and all Intel
Macintosh computers—which only offer PCI-X interfacing.
To use the SI-24 as a control surface:
m Simply connect it bi-directionally with two free (not used by other devices) MIDI
interface ports.
When used as a control surface, the SI-24 can be used with all Macintosh systems that
are capable of running Logic Pro. Obviously, you will require another device for audio
input and output.
To scan for your Roland SI-24 unit:
1 Choose Logic Pro > Preferences > Control Surfaces > Setup
2 Choose New > Install in the Setup window’s local menu.
3 Select Roland SI-24 in the Install window.
4 Click the Scan button.
Logic Pro will scan for, and automatically install, your control surface.