8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
168 Chapter 12 Mackie C4
 V-Select 20 switches to Sends Mixer view (see “Send Mixer View” on page 162).
 V-Select 21 switches to Effect Assign Mixer view (see “Effect Assign Mixer view” on
page 163).
 V-Select 22 switches to Instrument Select Mixer view (see “Instrument Assign Mixer
View” on page 164).
 V-Select 26 switches to Pan/Surround Channel view (see “Pan/Surround Channel
View” on page 160).
 V-Select 27 switches to EQ Channel view (see “EQ Channel View” on page 162).
 V-Select 28 switches to Send Channel view (see “Send Channel View” on page 163).
 V-Select 31 activates the Cycle view (see “Cycle View” on page 165).
 V-Select 32 activates the Drop view (see “Punch View” on page 166).
FUNCTION
Switches between Function overlay (see “Function Overlay” on page 170) and normal
view modes.
Modifier Buttons
The four buttons in this area are similar to those found on your computer keyboard
(but are independent of the keyboard modifiers). Many Logic Pro functions behave
differently when one or more modifier keys are pressed, in conjunction with another
key or mouse click. This also applies to the C4 control surface. All modified C4
commands are covered in each function description.
Here is a generic description of the modifier button functions:
 SHIFT: Switches other buttons to an alternate function.
 OPTION: While held down, parameters are set to the minimum, default, or maximum
value when edited with a V-Pot.
 CTRL: Disables the Group function.
Âx/ALT: While held down, parameters are edited in fine (high resolution) mode when
a V-Pot is turned.
BANK Left/Right
Shifts the parameter display by one page (a group of parameters) in particular views.
SINGLE Left/Right
Shifts the parameter display by one parameter in particular views.