8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
152 Chapter 10 Korg microKONTROL and KONTROL49
Send Overlay
Pressing SETTING while the encoders are in Send mode, changes the operation of the
Pads in Send mode.
Effect Edit Mode
This mode is enabled by pressing SCENE and Pad 13. In Effect Edit mode, the channel
strip encoders control the parameters of the currently selected effect. The Pads remain
in the currently selected mode.
Effect Edit Overlay
Pressing SETTING while the encoders are in Effect-in Edit mode changes the operation
of the Pads in Effect Edit mode.
Main Section
The main LCD shows information on the current mode of the encoders.
The LCD backlight is red while recording, and green at other times.
Pad Assignment
1–8 Switches the send bypass state (of the currently selected send) for the eight
channel strips.
9–16 Switches the send position (pre/post fader) of the currently selected send, for
the eight channel strips.
Pad Assignment
1–8 Switches the effect bypass state (of the currently selected Insert slot) for the
eight channel strips.
Display text Meaning
<Instrument name> Encoders edit instrument parameters.
<Plug-in name> Encoders edit effect parameters (xx indicates the currently selected Insert slot).
Automatn Encoders set the automation mode.
Ins. x (SETTING held down) Main encoder chooses the Insert slot number.
ModePad? Displayed while SCENE button is held down.
Pan Encoders control pan.
Send x Encoders control send level of send x.
User 6 Channel Strip User Mode 6. Encoders are initially unassigned.
User 7 Channel Strip User Mode 7. Encoders are initially unassigned.
User 8 Channel Strip User Mode 8. Encoders are initially unassigned.