8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 5 EuCon Support of Euphonix MC and System 5-MC 123
2 Select the desired Insert slot by pressing the respective knob top. Press the left Page
key to display Insert slots 9 to 15.
When you press the respective knob top, the Soft Keys display the Logic Pro plug-in
menu.
3 Choose the desired effect plug-in:
 Pressing the Soft Key or knob top enters a submenu or inserts a selected effect plug-
in.
 Pressing the Back key navigates up one level in the menu hierarchy.
Input Knobset
If the Input knobset is active, the Soft Keys display all possible channel input values for
audio channels:
 The first value is “--”, meaning no input.
 The currently active input value is indicated by a lit On key.
 Pressing the respective On key, Soft Key or knob top chooses the respective input
value.
 If there are more than eight values (inputs), the left Page key set switches to the
previous/next inputs.
 Pressing the two Page keys simultaneously switches to Input Configuration mode:
the Soft Keys display mode values (Mono, Stereo, Left, Right, Surround) for the
channel strip. Again, the active value is indicated by a lit On key. Pressing the
respective On key, Soft Key, or knob top chooses the value.
 Pressing the Back key returns to the top-level knobset.
Note: On software instrument channel strips, the Input knobset displays the inserted
instrument.
To edit an instrument:
m Press the respective knob top or Soft Key—on an instrument channel.
Instrument parameters are displayed in the order shown in the Controls view of the
plug-in. Turning a knob changes the parameter value. Pressing a knob top sets the
parameter to its default value. For parameters with only two values, the On key is lit
when the value is 1 (or on) and unlit when the value is 0 (or off).
To change, or insert, an instrument:
1 Press both Page keys simultaneously.
This switches to Insert Instrument mode. The Soft Key display indicates the Instrument
slot of the channel. When you press the knob top or Soft Key, the Soft Keys display the
Instrument plug-in menu.